Dfi ML905-B11C/B16C Manual de usuario descargar pdf (Pagina 14)

Hardware Installation

Important:

When the Standby Power LED lit red, it indicates that there is power on

the board. Power-off the PC then unplug the power cord prior to install-

ing any devices. Failure to do so will cause severe damage to the board

and components.

System Memory

Important:

Electrostatic discharge (ESD) can damage your board, processor, disk

drives, add-in boards, and other components. Perform installation proce-

dures at an ESD workstation only. If such a station is not available, you

can provide some ESD protection by wearing an antistatic wrist strap

and attaching it to a metal part of the system chassis. If a wrist strap

is unavailable, establish and maintain contact with the system chassis

throughout any procedures requiring ESD protection.

SODIMM

Standby

Power LED

The system board is equipped with one 200-pin SODIMM socket that supports

DDR2 memory modules.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 75 76

Sin comentarios

Dfi ML905-B11C/B16C Manual de usuario Pagina 14