Dfi CR902-B Manual de usuario Pagina 12

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 75
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 11
www.d .comChapter 3 Hardware Installation
12
Chapter 3
System Memory
DDR3_2
Standby
Power LED
The system board is equipped with two 204-pin SODIMM sockets that support DDR3(1.5V)/
DDR3L(1.35V) memory modules; depends on CPU supported. However, DDR3L memory mod-
ule can run at 1.5V.
DDR3_1
Important:
Electrostatic discharge (ESD) can damage your board, processor, disk drives, add-in
boards, and other components. Perform installation procedures at an ESD workstation
only. If such a station is not available, you can provide some ESD protection by wear-
ing an antistatic wrist strap and attaching it to a metal part of the system chassis. If
a wrist strap is unavailable, establish and maintain contact with the system chassis
throughout any procedures requiring ESD protection.
Important:
When the Standby Power LED lit red, it indicates that there is power on the board.
Power-off the PC then unplug the power cord prior to installing any devices. Failure to
do so will cause severe damage to the board and components.
Vista de pagina 11
1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 74 75

Comentarios a estos manuales

Sin comentarios