Dfi DT122-CR Installation Guide Manual de usuario

1DT122-CRInstallation Guidewww.dfi .com• 1 DT122-CR system unit• 1 HDD drive bay kit • 1 Quick Installation Guide• 1 CD disk includes: - Drivers/Man

102. Insert the spacer into the anti-shock bumper. You will fi nd the spacers in the HDD drive bay kit that comes with the DT122 package. lnstalling a

114. Use the provided mounting screws to secure the SATA drive onto the drive bay.5. Place the drive bay into the chassis. Secure the drive bay with t

12Important:When inserting the riser card, please select a card within 175mm (as shown on the nextpicture).Installing the PCI or PCIe x16Expansion Car

13BracketPCIe x16 slotMounting bracket and mounting screwPCI slotT200-1PT200-1E

142. Insert the Expansion card with a bracket into the PCI or PCIe x16 slot that is on the riser card. Replace the screw you removed in step 1 to secu

15There are 2 types of wall mount brackets: • Type A• Type BMounting Options Wall mountType A wall mount kit include:• 2 type A wall mount brackets 1

162. At the sides of the system, use the mounting screws removed in step 1 to secure the wall mount brackets on each side of the system.Mounting screw

17Type B wall mount kit include:• 2 type B wall mount brackets• Bracket screws1. The 4 mounting holes on the sides of the system are used to mount th

185.00R2.50R2.50Ø8.504.00300.00335.00360.0040.0055.0040.0055.0078.005.001637

19934-DT1220-200GA26212342Board Layout and Jumper SettingsUSB Power: 0-1/2-3 (JP6)/ 8-9 (JP8) +5V (default) 1-2 On +5V_standby 2-3 OnPS/2

2Front ViewPower ButtonHDD LEDPower LEDReset ButtonRear ViewMic-in/Center+SubwooferCOM 1Line-in/SurroundLine-outDVI-IHDMIUSB 2.0PS/2 Mouse/KBDVI-I(DVI

3Key FeaturesDT122-CRPROCESSOR3rd/2nd Generation Intel® CoreTM processorsCHIPSETIntel® QM77LAN2 LAN portsCOM 1 COM portDISPLAYS2 DVI-I (1 DVI-D Signal

4Removing the Chassis Cover1. Make sure the system and all other peripheral devices connected to it has been powered-off.2. Disconnect all power cords

54. After removing the mounting screws, slide the cover backwards. Slide the Cover Backward5. The DIMM sockets and SATA drive bay are readily accessib

61. Remove the 4 mounting screws that secure the drive bay to the system. Installing a 2.5" or 3.5" SATA Drivelnstalling a 2.5" SATA Dr

73. Align the mounting holes of the SATA drive with the mounting holes on the HDD bracket and then use the provided mounting screws to secure the driv

84. Turn to the other side of the drive bay. Use the provided mounting screws from step 2 to secure the SATA drive bay assembly onto the drive bay.Mou

96. Connect the SATA data cable and SATA power cable to the connectors on the SATA drive.SATA data cableSATA power cable