Dfi ES121-LR Manual de usuario descargar pdf (Pagina 150)

150

Supported Software

Installing the AHCI Driver During Windows XP Installation

The AHCI driver must be installed during Windows XP installation. This is required

in order to be able to install the operating system onto a hard drive that is con-

gured in AHCI mode.

1. When you insert the operating system’s installation disc into an optical drive,

the message Press any key to boot from CD will appear. Press Enter.

2. The message Setup is inspecting your computer’s hardware congura-

tion will appear.

3. Press F6 when prompted in the status line with the “Press F6 if you need to

install a third party SCSI or RAID driver” message.

4. Press S to “Specify Additional Device”.

4. Insert the oppy disk, containing the AHCI driver, into a oppy drive.

5. Select Intel(R) ICH8M-E/M SATA AHCI Controller then press Enter.

You have successfully installed the driver. However you must continue installing

the OS. Leave the oppy disk in the oppy drive until the system reboots itself

because Windows setup will need to copy the les again from the oppy disk

to the Windows installation folders. After Windows setup has copied these les

again, remove the oppy diskette so that Windows setup can reboot as needed.

1 2 ... 145 146 147 148 149 150 151 152 153 154 155 ... 174 175

Sin comentarios

Dfi ES121-LR Manual de usuario Pagina 150