Dfi ST101-CP Manual de usuario

1/91. Make sure the system and all other peripheral devices connected to it has beenpowered-off.2. Disconnect all power cords and cables.ST101-CPInsta

2/93. The drive bay bracket willresemble the one shown on theright.2. The 4 screws are used to securethe drive bay bracket. Removethese screws and put

3/91. Position the SATA drive at thebottom side of the drive baybracket.2. To secure SATA to the drive baybracket, you must fasten screwsfrom the top

4/94. After removing the drive baycover, on the top side of thebracket, position the optical driveas shown on the right.5. Secure the optical drive by

5/96. The figure on the right shows thecables for SATA drive, the powerconnector of the power supplyunit, and the locations of the SATAconnectors on t

6/99. Turn the drive bay bracket to thetop side. Insert the other end ofthe cable for DVD-ROM (C)through the bracket’s hole, upto the top side of the

7/911. Insert the drive bay bracketfrom the side of the system.12. Secure the drive bay bracket byfastening the screws youremoved earlier.13. Replace

8/92. The mounting holes are locatedat the bottom of the system.Mount the mounting rails on eachside of the system using themounting screws you havepu

9/9934-ST1011-171GA17521128Dimensions223.3070.10219.0070.10Packing List• 1 x ST101-CP system unit• 1 x ST101 chassis parts kit (cord holder, rubber fe